|* Features :|
Alnico magnets, composed of primarily aluminum, nickel, and cobalt, were developed in the 1940's. This class of magnet remains a preferred material because of it's excellent temperature stability, high magnetic flux density, and resistance to corrosion. Alnico magnets are manufactured through a casting or sintering process. The casting process allows for the magnet to be manufactured into intricate and complex shapes, which are not possible with other magnetic materials.
Excellent temperature stability, high residual induction, and relatively high energies characterize Alnico materials, composed primarily of alloys of Aluminum, Nickel, and Cobalt. They are manufactured through either a casting or sintering process. Cast magnets may be manufactured in complex shapes, such as horseshoes, not possible with other magnet materials. Sintered Alnico offer slightly lower magnetic properties but better mechanical characteristics than cast Alnico.
Cast Alnico 5 is the most commonly used of all the cast Alnico magnets. This material is used extensively in rotating machinery, meters, instruments, sensing devices, and holding applications, to name a few.
Alnico is hard and brittle. Cannot be Machined or drilled. Therefore be accomplished by ordinary methods. Holes are usually cored in at the foundry, and magnets are cast close to final size and then finish grinded to close tolerances.
Alnico has a low coercive force, and is easily demagnetized if not handled with care. For optimum performance of Alnico 5, the magnetic length should be approximately 5 times the pole diameter or equivalent diameter. For example, a 0.250" diameter magnet should be about 1.00" long.
Because of its higher coercivity, Alnico 8 may be used in shorter lengths and in disc shapes.
|* Performance Table :|